Steps:
Project details
Skill
Cost
Estimated Time
Tools & Materials
Circular saw
Track saw
Track saw guide system
Tape measure
Measure the offset of the circular saw guide to the blade. Mark whatever is being cut at the desired length, plus the offset.
Use a straight scrap piece of wood and place it on the measurement. Run the saw along the scrap piece of wood and the cut should be straight.
With a track saw, simply place the track along the desired length mark, offsetting for the thickness of the blade, and run the saw across the track.
Circular saws can also be converted to track saws using a guide system. It comes with a jig that can be attached to the bottom of any saw.
Make a track using two pieces of plywood. Cut one piece of plywood to be about 2” wide and glue it on top of the other piece.
Run the circular saw alongside the scrap piece on both sides. This will create an accurate guide accommodating the required offset for each side of the saw.
